PRVG-11069 : IP address “169.254.0.2” of network interface “idrac” on the node “primrac1” would conflict with HAIP usage

Problem:

Oracle 18c GI configuration precheck was failing with the following error:

Summary of node specific errors 

primrac2  - PRVG-11069 : IP address "169.254.0.2" of network interface "idrac" on the node "primrac2" would conflict with HAIP usage.  
- Cause:  One or more network interfaces have IP addresses in the range (169.254..), the range used by HAIP which can create routing conflicts.  
- Action:  Make sure there are no IP addresses in the range (169.254..) on any network interfaces. 

primrac1  - PRVG-11069 : IP address "169.254.0.2" of network interface "idrac" on the node "primrac1" would conflict with HAIP usage. 
- Cause:  One or more network interfaces have IP addresses in the range (169.254..), the range used by HAIP which can create routing conflicts.  
- Action:  Make sure there are no IP addresses in the range (169.254..) on any network interfaces.  

On each node additional network interface – named idrac was started with the ip address 169.254.0.2. I tried to set static ip address in /etc/sysconfig/network-scripts/ifcfg-idrac , also tried to bring the interface down – but after some time interface was starting up automatically and getting the same ip address.

Cluster nodes were DELL servers with Dell Remote Access Controller(iDRAC) Service Module installed. For more information about this module installation/deinstallation… can be found here https://topics-cdn.dell.com/pdf/idrac-service-module-v32_users-guide_en-us.pdf

Servers were configured by system administrator and was not clear why this module was there, we are not using iDRAC module and the only option that we had was to remove/uninstall that module. (configuring module should also be possible to avoid such situation, but we keep our servers as clean as possible without having unsed services)

Solution:

Uninstalled iDRAC module (also expained in the above pdf):

# rpm -e dcism 

After uninstalling it idrac interface did not started anymore, so we could continue GI configuration.